Hey,
I have another PC that I tested CAM on, and it was still just as bad as it was when I tested on my main PC, so I uninstalled it and did a system restore to before it was installed. Everything worked fine, and now HWiNFO displays the pump speed/liquid temps as it did before. (I know if you have the software open it won't show).
However, on my main PC, a few months ago I did the same thing... except now, it doesn't show the pump or liquid temp at all. It does show the label "NZXT Kraken x52/x62" but there's nothing under it. The only difference is that on my main PC, I updated the firmware, whereas on my other PC, I didn't. Did the firmware update block HWiNFO from accessing the data? If not, how can I bring it back? I'm guessing there's no way to reset the firmware on this device, so I'm hoping that's not the case.
Thanks!
I have another PC that I tested CAM on, and it was still just as bad as it was when I tested on my main PC, so I uninstalled it and did a system restore to before it was installed. Everything worked fine, and now HWiNFO displays the pump speed/liquid temps as it did before. (I know if you have the software open it won't show).
However, on my main PC, a few months ago I did the same thing... except now, it doesn't show the pump or liquid temp at all. It does show the label "NZXT Kraken x52/x62" but there's nothing under it. The only difference is that on my main PC, I updated the firmware, whereas on my other PC, I didn't. Did the firmware update block HWiNFO from accessing the data? If not, how can I bring it back? I'm guessing there's no way to reset the firmware on this device, so I'm hoping that's not the case.
Thanks!